Our Innovations
Our Innovations
The innovations behind every STERiJECT needle.
Every part of the needle-syringe system is a variable we engineer around your payload. None of it works in isolation: hub, cannula, bevel, gauge and materials are evaluated together considering the intended formulation, route and operating conditions.
Complete-system principle: Low dead space, cannula geometry and hub design should be evaluated with the intended syringe, formulation, route and operating conditions.
01 · Low dead space hub
Less trapped, more delivered
A standard hub can leave a meaningful share of a small dose behind at the connection. Every microlitre held there is prepared product that never reaches the patient. Our low-dead-space geometry reduces medication left in the hub, minimizing waste and supporting more accurate dose delivery.
02 · Advanced hub architecture
Built to hold under pressure
Hard-polymer, externally threaded hubs and streamlined internal transitions resist pop-off and turbulence, keeping the connection secure as injection pressure rises, so the needle stays put and the flow stays smooth from hub to tip.
03 · Thin-wall technology
Wider bore, same gauge
Thin-wall design provides a larger internal diameter, helping reduce the force needed to inject viscous formulations without increasing the needle’s outer diameter.
04 · Refined bevel & coating
Lower force, smoother glide
A precision bevel cuts penetration force, and a proprietary low-friction coating reduces drag through tissue. Together they support a more controlled, comfortable injection at the point of contact.
05 · Fine-gauge, precision length
Built for the smallest doses
Ultra-fine gauges down to 34G, paired with tightly controlled short lengths, give the most delicate procedures a repeatable penetration depth: consistency that matters most when the margin for error is smallest.
06 · Chemical compatibility
Matched to your formulation
Hub and contact materials are selected considering your excipients, pH and sterilization route, so extractables, leachables and adsorption are engineered out early rather than discovered late in development.
Shaping future technologies
Our innovation isn't finished; these six are where our engineering happens to be today. We keep testing new hub geometries, wall constructions and materials against real clinical and formulation problems, so the needle keeps improving alongside the therapies it delivers.
Next step
See these innovations in the product range
Compare how each hub technology (VLDS, VHPC and VPRC) combines these engineering decisions.